Send SMS
Product Search :

Chemtex Speciality Limited Chemtex Speciality Limited


Chemtex Speciality Limited


Home » Product Range » Water Treatment Chemicals » RO Chemicals » RO Membrane Disinfectant Biocide

RO Membrane Disinfectant Biocide

The RO Membrane Disinfectant Biocide, which is ideally used for eliminating biofouling and biofilms in the membrane of RO. The products which we cater under RO Membrane Disinfectant Biocide are RO Disinfectant, Membrane Biocide, Ro Antifoulant, Silver Hydrogen Peroxide based Disinfectant, Peracetic acid based RO Disinfectant, Drinking water Disinfectant etc. Continuous usage of reverse osmosis results into productivity reduction, increase power consumption, reduce flow rate and lower output quality. We formulate this biocide is non-oxidizing biocide that effectively responds against micro-organisms, bacteria and fungi.

High application rate, excellent protection from scale, improvise the RO performance, improvise the quality and precise pH value are the salient features of disinfectant biocide. With the application of this formulation, there is no requirement left for the chlorination and de-chlorination of feed water. These chemical formulations are utilized in the RO systems of food processing, water treatment plants and breweries.





RO Disinfectant

CHEMTEX'S RO Disinfectant is an effective non-oxidizing microbiocide for disinfection of RO membrane. It is safe for potable RO system. It has high efficacy rate for broad spectrum micro-organisms.

Key Features and Benefits
Application and Dosage
Dosage of CHEMTEX'S RO Disinfectant depends upon the degree of biological fouling. The recommended dosage is as follows:-

Shock Dose for Immediate Disinfection: 5-10% v/v conc. Continuous Dose for Round-the-clock disinfection: 2.5ppm on feed max.

Membrane Cleaning: System should be disinfected with CHEMTEX'S RO Disinfectant, then flushed with permeate water and then circulate solution of ALKRO CL27 for 30 min and soaked for 1-2hrs. Flush the system with permeate water and pass solution of ALKRO CL21 (if required). Once again flush the system with permeate and return plant to normal service.

The dosage of cleaning solution depends upon the frequency of cleaning and degree of fouling.

Note: Replace the solution with new one if the cleaning solution becomes severely fouled and turbid. In multi-pass systems, best results can be achieved if each pass is individually cleaned.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator, gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected. Please refer MSDS for more details.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S RO Disinfectant is available in various pack sizes, packed in HDPE containers.






Membrane Biocide

CHEMTEX'S Membrane Biocide is used for disinfection of membrane and also to kill pathogens to prevent water borne diseas and bio-fouling. It comes in two variants \96 oxidising and non-oxidising microbiocide for disinfection of RO/NF/UF membrane. Oxidising biocide is safe for potable RO system. It has high efficacy rate for broad spectrum micro-organisms.

Key Features and Benefits
  • Broad spectrum MicroBiocide
  • Biodegradable
  • Totally chlorine free
  • Safe for potable water RO system
  • Compatible with all parts and components of RO Membrane System

Application and Dosage
Dosage of CHEMTEX'S Membrane Biocide depends upon the degree of biological fouling. The recommended dosage shall be guided by your CSL technical representative.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator, gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected. Please refer MSDS for more details.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S Membrane Biocide is available in 20kgs and 35kgs HDPE containers.






RO Antifoulant

CHEMTEX'S RO Antifoulant is a super-threshold RO membrane antiscalant and antifoulant which is able to stabilize a wide range of supersaturated salt solutions, thereby preventing the precipitation on the membrane surface.

It reduces the risk of scaling and eliminates the use of hazardous acids, resulting in efficient plant operation with highest possible conversion rate.

It is a very effective antiscalant for waters with LSI upto +2.5, Iron upto 1.2ppm in reject, High SDI.

CHEMTEX'S RO Antifoulant is effective in minimizing scaling in presence of foulants like Calcium Carbonate, Sulfate salts of Calcium, Barium, Stronium and Magnesium, Calcium Fluoride, Iron and Silica found in surface, ground and sea water.

Key Features and Benefits
  • Effective scale inhibition
  • High recovery rate
  • Low chemical dosage
  • Cost Effective
  • Effective Iron fouling control by sequestration
  • Reduced frequency of membrane cleaning
  • Compatible with all types of membranes
  • Completely organic and biodegradable

Application and Dosage
CHEMTEX'S RO Antifoulant is dosed directly to the RO feed water tank or feed water line (after pretreatment, prior to cartridge filter) at the neat dosage of 1ppm to 8ppm, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content. For calculating the exact dosage for your system, please contact your CSL representative.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator, gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected. Please refer MSDS for more details.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S RO Antifoulant is available in 20kgs HDPE carbuoys and 250kgs HDPE barrels.






Silver Hydrogen Peroxide based Disinfectant

CHEMTEX'S Silver Hydrogen Peroxide Based Disinfectant is a synergised blend of Hydrogen Peroxide IP Grade with Silver Nitrate IP grade alongwith various stabilizers, stabilized and manufactured with pH, pressure and temperature controlled process.

Silver Hydroge Peroxide is used for multiple applications to disinfect air, water and surface. It is biodegradable disinfectant and finds its use comfort and flexibility to disinfect almost anything. The composition of Silver Hydrogen Peroxide manufactured by Chemtex Speciality Limited is FDA approved and non-toxic for use in potable water disinfection, CIP disinfection of food and beverage equipments etc.

Key Features and Benefits
  • Cold Sterilant (Does not require heat for disinfection)
  • Effective over a large range of micro-organisms at very low concentration
  • Non-foaming and suitable for CIP disinfection, spraying, fogging and fumigation
  • Eco-friendly and Bio-Degradable
  • Non-tainting and non-staining product
  • Non-carcinogenic (unlike Formalin)
  • Does not emit harmful fumes (unlike chlorine, bromine, formalin and other aldehydes)
  • No rinse required
  • Silver ions give added benefit as bacteria-stat and non-mutagenic
  • Completely organic
  • Does not leave toxic residue
  • Does not leave back odor after fumigation
  • Destroys bio-film
  • Oligo-dynamic characteristic of Silver
  • Does not form any coating on the surface after fogging

Application and Dosage
CHEMTEX'S Silver Hydrogen Peroxide is recommended for use on pre-cleaned surfaces such as equipments, pipelines, tanks, vats, filters, evaporators, pasteurizers and aseptic equipments in dairies, breweries, wineries, beverage and food processing / packaging plants and egg processing and packaging equipment surfaces.

CHEMTEX'S Silver Hydrogen Peroxide Based Disinfectant is also used for bacterial eradication of process water, fruits and vegetables, water tank disinfection, poultry, pharma, dairy, duct disinfection, cooling tower, leginella treatment, air conditioning filters, pans etc. and almost every possible disinfection.

The dosage depends on applications, ranging from 0.002 \96 0.5% w/w, followed with proper rinsing with potable water. For specific dosage rate, please refer your CSL technical representative or method of use sheet.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator, gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected. Please refer MSDS for more details.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S Silver Hydrogen Peroxide Based Disinfectant is available in 20/35kgs HDPE jars.






Peracetic Acid based RO Disinfectant

CHEMTEX'S Peracetic Acid Based Ro Disinfectant is a highly effective oxidizing microbiocide for disinfection of RO/NF/UF membrane. It is safe for potable RO system. It has high efficacy rate for broad spectrum micro-organisms.

Key Features and Benefits
  • Broad spectrum MicroBiocide
  • Biodegradable
  • Totally chlorine free
  • Safe for potable water RO system
  • Compatible with all parts and components of RO Membrane System

Application and Dosage
Dosage of CHEMTEX'S Peracetic Acid Based Ro Disinfectant depends upon the degree of biological fouling.

The recommended dosage is as follows:-
Shock Dose for Immediate Disinfection: 5-10% v/v conc. Continuous Dose for Round-the-clock disinfection: 2.5ppm on feed max.

Membrane Cleaning: System should be sanitized first with ALKRO with permeate water and then circulated with solution of CHEMTEX'S PERACETIC ACID BASED RO DISINFECTANT, then flushed CL27 for 30 min and soaked for 1-2hrs. Flush the system with permeate water and return plant to normal service.

The dosage of cleaning solution depends upon the frequency of cleaning and degree of fouling.

Note:
Replace the solution with new one if the cleaning solution becomes severely fouled and turbid. In multi-pass systems, best results can be achieved if each pass is individually cleaned.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator, gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected. Please refer MSDS for more details.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S Peracetic Acid Based Ro Disinfectant is available in 20kgs and 35kgs HDPE containers.






Drinking Water Disinfectant

CHEMTEX'S Drinking Water Disinfectant is a synergised blend of silver and peroxide, stabilized for use as general purpose sanitizer for use mainly in CIP system for tanks, pipeline etc. in food and beverage industry, dairy etc. CHEMTEX'S Drinking Water Disinfectant is no rinse, no odor, non-tainting,non-toxic, non-staining and non foaming formula and is very able to sanitize at cold temperature. It is used for potable water disinfection.

Key Features and Benefits
  • Effective disinfectant in Cold plant operation
  • Excellent Rinsability
  • Effective over a large range of bio-organisms at very low concentration
  • Non-foaming and suitable for CIP disinfection
  • Can be used in various applications as disinfectant
  • Non-tainting and non-staining product

Application and Dosage
CHEMTEX'S Drinking Water Disinfectant is recommended for use on pre-cleaned surfaces such as equipments, pipelines, tanks, vats, filters, evaporators, pasteurizers and aseptic equipments in dairies, breweries, wineries, beverage and food processing / packaging plants and egg processing and packaging equipment surfaces.

CHEMTEX'S Drinking Water Disinfectant is also used for bacterial eradication of process water, fruits and vegetables, Air conditioning filters, pans etc.

The dosage depends on applications, ranging from 0.002 - 10% w/w, followed with proper rinsing with potable water. For specific dosage rate, please refer your CSL representative or method of use sheet.

Handling measures and precautions
Proper human safety products such as Splash goggles, lab coat, vapor respirator,gloves and boots should be worn while handling and applying chemicals. Splashes on skin should be washed off with water immediately. In case of splashing into the eyes, flush it with fresh water and obtain medical attention. Should not be injected.

Storage
This product should be stored in original containers in cool and dry place, away from sources of heat, flame and direct sunlight. Please refer Technical Data Sheet, Label and MSDS for more details and shelf life.

Packing
CHEMTEX'S Drinking Water Disinfectant is available in 20/35kgs HDPE jars.






x

Send SMS Enquiry

*Please Enter Requirment

*Please Enter valid Mobile Number

*Please Enter Proper Name